Buy 1.8 inch TFT LCD Module Online in India | Robocraze

1.8 inch TFT LCD Module

This is the 1.8 inch TFT LCD Module. This TFT LCD display module communicates via 4-wire SPI and has its own pixel-addressable frame buffer; it can be used with any type of microcontroller, even very small ones with limited memory and few available pins.

The 1.8″ TFT LCD display features 128×160 colour pixels. This display is a true TFT, unlike low-cost “Nokia 6110” and similar LCD displays, which are CSTN type and thus have poor colour and slow refresh. The ST7735R TFT driver can display full 18-bit colour (262,144 shades!), making it ideal for vibrant graphical interfaces.

If you're comparing the 1.8 inch TFT LCD price India, this module offers a great balance between performance and affordability for DIY electronics, embedded systems, and IoT projects.

The LCD will always come with the same driver chip, so you won’t have to worry about compatibility issues across units. The TFT display is soldered to the breakout (using a delicate flex-circuit connector), along with an ultra-low-dropout 3.3V regulator and a 3/5V level shifter, allowing seamless use with both 3.3V and 5V systems.

If you want to use this 1.8 inch TFT LCD display Module with Arduino, in your project for that you will need few essential components like

• breadboard
• jumper wires 

Features:

• Display Size: 1.8 inch TFT
• Resolution: 128 × 160 pixels
• Driver IC: ST7735R
• Interface: SPI (4-wire)
• Operating Voltage: 3.3V / 5V compatible
• Built-in voltage regulator and level shifter
• Full RGB colour support (18-bit)
• Compact and lightweight design

Arduino Code Example:

#include 
#include 
#include 

// Pin definitions
#define TFT_CS     10
#define TFT_RST    9
#define TFT_DC     8

Adafruit_ST7735 tft = Adafruit_ST7735(TFT_CS, TFT_DC, TFT_RST);

void setup() {
  tft.initR(INITR_BLACKTAB);   // Initialize display
  tft.fillScreen(ST7735_BLACK);

  tft.setTextColor(ST7735_WHITE);
  tft.setTextSize(2);
  tft.setCursor(10, 30);
  tft.print("Hello!");
}

void loop() {
  // Nothing here
}