Woooooooow very very good and very good product im so happy and packaging super
I have make a remote control car
Product worked well for my Linux pc, no drivers needed, simple installation.
ST-Link V2 Debugger and Programmer USB
Couldn't load pickup availability
The ST-Link V2 debugger and programmer is designed for STM8 and STM32 and is manufactured with PCB installed inside of aluminum alloy U disk shell. This factory firmware has been upgraded to support the full-range STM32 SWD and a full-range STM8 SWIM.
This ST-Link programmer is equipped with a 500MA internal resettable fuse that provides complete protection for your expensive computer motherboard. This programmer has a programming speed rate of 9.7 Kbytes/s in low speed and 12.8 Kbytes/s in high speed. It has a red and blue LED indicator that allows users to observe the working condition of the Programmer.
The ST-Link device can be used to send program code to the 32-bit STM32 ARM Cortex or 8-bit STM8 microcontrollers. It contains connections for 5V, 3.3V, SWCLK, SWDIO, SWIM, Reset (RST/NRST), and GND. With the help of the USB connector, it can connected to a computer.
ย
Note: This ST-Link Programmer will not get detected in the STM32CubeIDE as they are clones.
Clickย here to download the Drivers.
| Case Material | Aluminium Alloy |
| Input Voltage | 3.3V - 5V |
| Programming Speed | 9.7 Kbytes/s - 12.8 Kbytes/s |
| Operating temperature | 0 to 50ยฐC |
| Fuse | 500MA |
| Dimensions | 5.5 x 1.5 x 0.5cm |
| Weight | 15 grams |